Hey there,

Hoping someone could point me to a PCB that is using a Blackpill and a ST7789V OLED display. I have the above and am not 100% on which pins to wire up. GND is obvious. VCC I’m pointing to 3.3V, then there is:

  • CS
  • DC
  • Reset
  • SDA
  • SCL

The smaller screens only have SDA & SCL. Can anyone confirm whether the others are optional, mandatory, whether there are specific/preferred pins?

I’m feeling a little lost at the moment, so hoping for some guidance.

FYI this is the specific display: here

  • BOFH666@lemmy.world
    1·
    1 year ago

    No experience with qmk on these controllers, but connected several of these oled displays to esp32 microcontrollers without any problems.

    CS, SDA and SCL will be your spi bus, the D/C is an output (from controller pov, input for the display) to signal the ‘mode’ of operation.

    Good luck.