I voted.

These next four years are for you.

Lack of new content on lemmy. Go post.

Naw, this is literally the conservative mind set. Even if someone doesn’t vote for republicans, thinking like this is conservative thinking.

That’s just it. Your mil sitting in a bank is not their profit yet.

I’ll just repeat myself, Why do you think NY taxi cabs are so popular there if everyone wants to take the subway or a bus?

Have you ever tried to drive around NYC? You can’t. Too much traffic. Why do you think taxi cabs are so popular there if everyone wants to take the subway or a bus.

Passenger safety is a real barrier.

Go for an iron with temperature control and a fine, chisel tip. There are many good brands, Weller is market leader, but cheaper irons can work well too. The chisel tip adds more surface area for more heat conduction.

Flux is very important. No good soldering happens without Flux. Also important to keep a clean tip. I recommend tinning the wire or the contact pad and tinning the iron tip. This should give you enough solder to make the joint without having to hold a piece of solder.

I love Cardas Audio Quad-Enteric solder https://www.cardas.com/supplies Super low melting point makes it great for electronics parts that might be damaged by too much heat.