First off thank you so much this is exactly what I’ve been waiting for.

I looked at the compose file and it doesnt seem to have the base image in there, just the DB and web setup.

I’m not super experienced with docker but would love to deploy this through my dockstarter setup - am I missing something here, is there a way to get it up and running through compose now?

Thanks!

Well to try and answer your questions:

• It does work
• Its not really unreadable so its fine
• I think it dries the same, I’d have to ask my other half
• The lint trap still works well because its vented so the air still passes through it

We’ve been using it the right way up for years so lint had collected in the botton of the actual unit and when I mounted it upside down that all fell through the unit body. It did cause it to smell like burning fabric for the first 30 mins running it upside down down but I just stood next to it with a fire extinguisher until it “burnt off” the smell you could say.

Now been running perfectly with no burning smell for 10ish loads of laundry!

What about now?

Sorry, it is an option to be mounted on the wall.

Normally it would sit right side up in a stack or on the floor, by wall mounting you have to flip it so the controls are at the bottom which turns them upside down.

Its not an issue cause like I said in another comment its a number dial and a hot/cold toggle, nothing hard to figure out

Nah it was sitting right side up on the floor - they are upside down now

Front loaders tend to have smaller capacity and harder to keep clean / sanitary so we opted for the top loader

Not a gas, electric heating element

This is Sylvie

Motherfuckers.

I’m sorry to hear that mate

You must live next door

Ill update if that happens but I like to think I’m pretty good on the tools to avoid that.

All from Hammerbarn, I think 20 bucks a shelf I cant remember. Rails were 20 each and the shelf arms were a few bucks each.

No it was sitting right side up on the floor

They absolutely were not but its just a dial with numbers and a hot/cold toggle, nothing too dramatic.

Made for it - comes with a kit to wall mount if required.

The wall on the left is out of level by about 15mm bottom to top. However I have a laser level and it makes life very easy when needing to do any of this stuff.

Maybe this is less dull than I thought - perhaps mildly interesting?

It doesnt really vibrate much, simple belt driven barrel and a heating element.

The thing is 40kg fully loaded so it would take a fair whack for it to come off the mount which is supported across 3 studs.

Good ol’ vented - didnt know condensing ones existed

So I can reach the controls